Joined: Fri May 23, 2003 6:26 pm Posts: 3108 Location: South West
|
If I remember right it goes up the bulkhead on the inside over to the passenger side then comes out into the engine bay under the little 10mm lip then goes into a t piece which has a one way valve in it. I think. One part goes around the passenger side of the bay and into the top of the washer bottle and the other part goes above the 10mm lip in the engine bay then into the space behind the bonnet latch plate onto the nozzle.
To be honest unless you are doing a concours popular spec model I would get a switch from a ghia/xr2 and wire that up. It's quite straight forward.
|
|